PV063R1K1T1NFF1 Parker PVPlus Axial Piston Pumps Parker Hydraulic Pumps Slagger Hydraulic Systems

 With thru drive for single and multiple pumps                   

Swash plate type for open circuit

 Technical Features                                                         

• Low noise level

• Fast response

• Service-friendly

• High self-priming speed

• Compact design

• Thru drive for 100% nominal torque

 General Information                                                      

Fluid recommendations

Premium quality hydraulic mineral fluid is recommended,like HLP oils to DIN 51524, part 2. Brugger- value has to be 30 N/mm2 minimum for general application and 50 N/mm2 for heavily loaded hydraulic equipment and fast cycling machines and/or high dynamic loads, measured in accordance with DIN 51 347-2. See also Document HY30-3248/UK Parker Hydraulic Fluids.

Viscosity

The normal operating viscosity should range between 16 and 100 mm2/s (cSt). Max. start-up viscosity is 800 mm2/s (cSt).

Filtration

For maximum pump and system component functionality and life, the system should be protected from contamination by effective filtration.

Fluid cleanliness should be in accordance with ISO classification ISO 4406:1999. The quality of filter elements should be in accordance with ISO standards.

General hydraulic systems for satisfactory operation: Class 20/18/15, according to ISO 4406:1999

Recommended cleanliness for maximum component life and functionality: Class 18/16/13, according to ISO 4406:1999

 Seals                                                                  

Check hydraulic fluid specification for chemical resistance of seal material.

Check temperature range of seal material and compare with max. system and ambient temperature.

N – Nitrile (FKM shaft seal) -25…+90 °C

B – Nitrile (NBR shaft seal) -40…+90 °C

V – FKM (FKM shaft seal) -25…+115 °C

W – Nitrile (PTFE shaft seal) -30…+90 °C

P – FKM (PTFE shaft seal) -25…+115 °C

Note: The highest fluid temperature will be at the drain port of the pump, up to 25 °C higher than in the reservoir.

 Technical Data